Originally Posted by
randyc
In RA2 you can add a delay of up to 4 hours on the off/unoccupied setting. Keep in mind this delay will occur every time. If you have the sensor set at 30 minutes and the delay set at 30 minutes you are going to have to wait an hour for the lights to go off... every time. You will also have 2 timers in place. One in the sensor and one in the RA2 software. If the sensor times out and sends the signal to the RA2, the software starts its 30 minute delay. If motion occurs half way through the delay, I don't think the delay gets reset. I believe the lights will turn out 15 minutes later (end of the delay). I haven't tried it so I'm not 100% sure on that.