I am trying to run commands on a Linux PC from a HWQS system. I am using HWQS v15.7. I have an outbound Ethernet device set up to connect to the Linux system. However, the HWQS system does not appear to be able to login to the Linux box. Username, password, IP address, port number all look correct. I can telnet to the Linux system and login with the configured username and password from another PC on the same subnet. The "outboundconnections" command on the HWQS system says "Connection state : Attempting to log in".Here is the full message:Device name : Linux2 HostDevice object ID : 46932Integration IP Address : 10.128.0.3 Integration Port : 23 Socket Number : 10 local port : 10001Connection Type : TelnetIs connected through ethernet : YesConnection retries : 0Authentication sent : NoLogin : lutronConnection state : Attempting to log inSeems like I must be doing something simple wrong. Also, what manual describes commands like "outboundconnections" ? If someone can point me to the doc that describes that command it would be helpful.Thanks,Larry