Hi all, I am using the Grafik T (GTJ-250M-WH) in the reno of my front room to assess whether I should use it as the new standard throughout the rest of my house. In general it works (on/off, dimming without flickering), however I am experiencing 2 separate issues that I have not fully solved. It is possible these are not issues and I misunderstood the product, but any help is much appreciated. 1. When I slide my finger it is not a smooth slow transition through a full dimming spectrum, but jumps between the 7 LED buttons. Is this the intended function? Are there only 7 dimming levels or should I be able to achieve a full spectrum as I slide my finger up and down? The videos seemed to give the impression of a full smooth spectrum. 2. The dimming is quite jumpy from LED 1 to LED 7. At first, buttons 2-7 were basically the same, close to max brightness with ever so slight variations. I thought this might be an issue with the settings/compatibility with the LEDs and I just need to reset the max light level to something a bit lower, and the lowest light level to something a bit lower. There does not seem to be an even split from 1-7 between the lowest and maximum brightness after setting this within the APM mode. There is noticeable jump from LED 1 to LED 2 to LED 3 with the rest being closer together (albeit, much better than before I adjusted the settings in APM mode). Any thoughts? Thanks in advance for your help!