I installed the following caseta hardware in my home:
- 7 PD-5NE ELV+ dimmers
- 2 PD-6ANS switches
I am experiencing some issues:
"Flashing" - Approximately once every 30 seconds or so, when a 5NE dimmer is in a dimmed position, the light will "flash" up to its full brightness for a fraction of a second. Almost like a voltage surge or something. When at full brightness, I don't notice anything
"Resetting" - Once every 10 - 15 minutes or so, when a 5NE dimmer is in a dimmed position, the light will turn off completely and then return to the dimmed state that it was in before it "reset." When at full brightness, I don't experience any issues.I experience these issues in all zones but are most pronounced in ELV zones and I have only seen the "reset" in ELV zones.
About the loads:
- In all zones, incandescent or halogen bulbs are being used
- 2 zones (bathrooms) contain MLV transformers so forward dimming is being used
- 4 zones contain ELV transformers so trailing dimming is being used
- 1 zone is incandescents with no transformer so I have tried using both forward and trailing but mainly leave it on forward
Wiring:
- Neutral wiring throughout my home so neutrals are connected for all dimmers and switches
- LED strip load on one of the switches so a LUT-MLC is being used to prevent flashing
I've tried changing bulbs and isolating switches from the system but I haven't found anything that has had an effect.
Tried speaking to Lutron support but the tech that I spoke to did have any good ideas. I also emailed Lutron support and the tech thought there could be some neutral wire noise but I don't know how to fix that.
Any ideas?