I have two zones on the VIVE hub. One zone has a Vacancy sensor only. The other zone has a pico dimmer switch and a vacancy sensor. Both zones have the RMJS-8T-DV-B Pow Pak. The zone with the pico switch has been set up through the VIVE hub to dim the lights in that zone to 50% when the vac sensor times out. It works fine, except the lights come on full before the switch is touched. The vacancy sensor is acting like an occupancy sensor. The other zone is set up the same way except there is no PICO switch paired in. This zone will not dim to 50% when the vacancy sensors time out. It's full on or off. The vacancy sensors act like occupancy sensors and turn on the zone.