Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Blinking LEDs on Dim Cycle

  1. #1
    Junior Member
    Join Date
    Jun 2019
    Posts
    14

    Blinking LEDs on Dim Cycle

    Another system (Vantage) supports a dim cycle in a different way than Lutron. When the user does a press-hold, the lights will dim to off, then immediately change to brighten. This is a very intuitive and convenient interface.

    Lutron requires that to do the same, the user has to press a button to cause dimming, release the button, wait a few seconds while the LEDs dim, and then can press the button to brighten the lights.

    Is there a way to program a Lutron system to do the same, or at least get close? Can we eliminate the release and wait? Can we shorten the time when the LEDs are brightening, so a user could almost immediately press the button a second time to start brightening the lights?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,968
    I've never experienced the "few seconds" thing. Every time I have used cycle dim, if you release for 2 seconds the button goes back to toggle mode.
    LED, Incorporated
    Raleigh, NC 27614

  3. #3
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    168
    Thank you for your Post KayRJay.

    We would need to have release and wait. That is what tells us what direction to go in. We would recommend emailing in to hwsupport@lutron.com so we can further discuss what we are looking to do and what our options are for your programming request. Hope this helps!

Similar Threads

  1. Replies: 6
    Last Post: 02-08-2019, 02:29 AM
  2. Cycle Dim Issue
    By Mario in forum Troubleshooting - HWQS
    Replies: 2
    Last Post: 03-23-2017, 03:02 PM
  3. Mains voltage dimmable LEDs vs Low Volatge dimmable LEDs with transformers
    By etienneterblanche in forum General Discussion - LED
    Replies: 5
    Last Post: 09-17-2014, 01:27 AM
  4. Blinking LEDs on 6D
    By schalliol in forum Troubleshooting - RA2
    Replies: 2
    Last Post: 07-30-2014, 06:12 PM
  5. 600w dimmers LEDs blinking - not responding
    By jelston in forum Troubleshooting - RA2
    Replies: 6
    Last Post: 12-20-2013, 02:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •