Thanks Thanks:  0
Likes Likes:  0
Results 1 to 5 of 5

Thread: Crestron module has a 50 ID limit; is there one that is 70 ID ?

  1. #1
    Junior Member
    Join Date
    Aug 2018
    Posts
    5

    Crestron module has a 50 ID limit; is there one that is 70 ID ?

    The system I am working on needs 66 IDs ! the Crestron Module is set at 50 IDs.The UMCs are protected so no chance to expand them with out the KEY or a module with the 70 IDs.Any information is helpful thanksjerry

  2. #2
    Hello. I'm not aware of a unit that will allow 70 ID's. You may need to reach out to Crestron to see what they can advise as this is often a problem being the Caseta System (75 device limit) and RA2 Select systems (100) device limit) both have limits higher then what the Crestron driver allows.

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,963
    The last time I looked, Crestron will not write modules for non-Crestron lighting systems. You will need to contact who ever wrote the module you have and see if they have an updated version. Lutron did write a couple of Crestron modules. If you have a module written by Lutron, you will need to contact Tech Support to get the update procedure started.
    LED, Incorporated
    Raleigh, NC 27614

  4. #4
    Senior Member
    Join Date
    Sep 2014
    Posts
    119
    You will have to email Lutron and hopefully they can forward this request to the module developer. You will probably get better results though reaching out directly to Control Concepts Inc who wrote the QS Crestron modules, so I assume they did the Caseta/Ra2 Select modules.

    I too have issues with the latest QS modules and Lutron support have been mostly useless so I am going to try Control Concepts.

  5. #5
    Junior Member
    Join Date
    Aug 2018
    Posts
    5
    Thanks Johnmax. I emailed Lutron they said contact Crestron. I asked crestron they said contact Lutron go figure!I had good luck using the 50IDs so far. I have 67 IDs. Removed all picos then used those IDs for Dimmers, Fan and Switches until I ran out of IDs up to 50. then reinstalled Pico remotes, switches, dimmers beyond 50 IDs.Crestron is really flexible to get around the need for IFTTT needs and logic.thanks for noting Control Concepts, I will also reach out to them.

Similar Threads

  1. Lutron Homeworks Series 5 processor Crestron Module
    By benchris in forum General Discussion - Legacy HW
    Replies: 5
    Last Post: 05-02-2019, 01:29 PM
  2. Crestron, Control4, & URC integrations
    By asherrick in forum 3rd-party Integration - CAS
    Replies: 3
    Last Post: 06-29-2016, 04:55 PM
  3. Crestron shade control
    By PACHAWAII in forum 3rd-party Integration - HWQS
    Replies: 2
    Last Post: 05-08-2015, 01:48 PM
  4. Integration with Crestron
    By MitchE in forum Troubleshooting - RA2
    Replies: 0
    Last Post: 03-11-2015, 06:18 PM
  5. Replies: 1
    Last Post: 12-10-2014, 12:28 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •