Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Lighting intensity not going to maximum.

  1. #1
    Junior Member
    Join Date
    Sep 2020
    Posts
    1

    Question Lighting intensity not going to maximum.

    I've had a MACL-153M Dimmer for about 2.5 years. I've noticed the light level is not what it used to be and thought it was the bulbs (LED). However, I've found that when I toggle up the indicator lights manually from the lowest level, after I4 the light level does not change between I4 and I7...any suggestions of what's up?

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    272
    Hi MPoole, the MACL-153M does have a feature that allows you to adjust the high end trim. This will allow you to adjust how high the dimmer will brighten the lights. I've included a link that will take you to the programming guide: https://www.lutron.com/TechnicalDocu...ary/048459.pdf

Similar Threads

  1. Changing Keypad Backlight Intensity
    By budd1e_lee in forum General Discussion - HWQS
    Replies: 4
    Last Post: 02-10-2020, 11:06 AM
  2. Maximum voltage for PDW-6WCL-WH-A
    By raker80 in forum General Discussion - CAS
    Replies: 1
    Last Post: 11-04-2019, 09:42 AM
  3. Control RGBW Intensity on QS link with QSE-CI-DMX
    By dexter4000 in forum Programming - HWQS
    Replies: 2
    Last Post: 12-19-2017, 11:26 AM
  4. Back light intensity
    By donkeyface in forum Programming - HWQS
    Replies: 2
    Last Post: 06-20-2017, 12:00 PM
  5. Keypad Back Light Intensity
    By mcignarella in forum Troubleshooting - HWQS
    Replies: 11
    Last Post: 09-18-2014, 08:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •