Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: Re-Assigning DALI Ballasts

  1. #1
    Junior Member
    Join Date
    Sep 2020
    Posts
    2

    Question Re-Assigning DALI Ballasts

    In Homeworks QS --- If I have a DALI loop with ballasts that have already been assigned, is there a quick way to move a ballast from one load to another? For instance, a group of 6 downlights was commissioned as 1 zone, and then the designer decides to take two of those downlights and make them a separate zone. It seems the only way would be to completely re-activate the entire loop? But I may not want to alter the other 62 remaining ballasts on the loop...It seems that the Grafik Eye DALI is much more intuitive when it comes to moving ballasts from one zone to another, whereas in HWQS it is much harder, and surely it should be the other way around...!

  2. #2
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    238
    Thank you for your post EBlight.

    If they were activated as whole zone, you could deactivate that one zone and then make the change to the zone to break it. If that would not resolve the issue we would need to re do the entire loop. As a quick reference we do have this app note found here at https://www.lutron.com/TechnicalDocu...LI_in_HWQS.pdf that may be helpful!

  3. #3
    Junior Member
    Join Date
    Sep 2020
    Posts
    2
    Thanks Josh - yes as i thought the DALI stuff isnt as advanced as it should be in HWQS yet...
    Quote Originally Posted by Josh R. View Post
    Thank you for your post EBlight.If they were activated as whole zone, you could deactivate that one zone and then make the change to the zone to break it. If that would not resolve the issue we would need to re do the entire loop. As a quick reference we do have this app note found here at https://www.lutron.com/TechnicalDocu...LI_in_HWQS.pdf that may be helpful!

Similar Threads

  1. Caseta Wireless and Flourescent Ballasts
    By teggy in forum General Discussion - CAS
    Replies: 5
    Last Post: 07-24-2017, 08:03 AM
  2. Some ballasts on the same rail are not dimming
    By Babsuntech in forum Programming - HWQS
    Replies: 2
    Last Post: 01-14-2017, 04:30 PM
  3. Assigning 1 phantom button for multiple shades
    By u57jcs in forum Programming - Shades
    Replies: 4
    Last Post: 02-20-2016, 03:28 AM
  4. Replies: 0
    Last Post: 01-29-2016, 01:16 PM
  5. Assigning Loads in QS 8.3
    By Kevin Craig in forum Design Assistance - HWQS
    Replies: 2
    Last Post: 08-17-2015, 06:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •