Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Settings Trouble with Occupancy Sensing Switch

  1. #1
    Junior Member
    Join Date
    Aug 2020
    Posts
    1

    Unhappy Settings Trouble with Occupancy Sensing Switch

    I just installed a Lutron Occupancy Sensing Switch. At first, the light was off. Don't know what I did but it came on. It's been over five minutes (the default setting) and the light did not go off. I tried to change the timeout settings, held the button as shown in the picture but no sensor light flashed. Same thing with changing the sensor mode, held the button on the side but no sensor light flashes. I even tried to reset all settings to default by holding both buttons, the sensor light didn't flash. The switch's ground wire is connected to the ground wire in the switch box. Any ideas what is going on?

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    272
    Hello iamoraal, we're sorry to hear about the issue you're having with your Maestro sensor. If you are also unable to manually turn the lights off then the sensor may not have a strong enough ground connection. We'd suggest making sure that the green ground wire from the sensor has a good connection with the bare ground wire in your wall. There should have also been a white sleeve in the packaging with the sensor, this can go over the green ground wire on the sensor and then connect that wire to the bundle of neutrals in your wall. With this connection you should now be able to control the switch and have the sensors functioning. If it still isn't working for you, then I'd suggest giving out Tech Support team a call so we can help troubleshoot this for you.

Similar Threads

  1. Occupancy Flashes on Sensing but stays off until manual select
    By hawkiz6 in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 05-02-2018, 12:26 PM
  2. 3rd party control over timeclock changes to motion sensing?
    By wkearney99 in forum 3rd-party Integration - RA2
    Replies: 7
    Last Post: 02-20-2018, 11:08 AM
  3. Replies: 2
    Last Post: 01-11-2018, 01:23 PM
  4. Occupancy sensor - daylight sensing
    By svale_sp in forum Troubleshooting - Controls
    Replies: 5
    Last Post: 08-11-2017, 03:50 AM
  5. Changing the Occupancy settings on a Lutron EnergiSavr system
    By Joe M. in forum Programming - General Commercial
    Replies: 0
    Last Post: 09-02-2016, 04:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •