Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Using Ethernet Device module

  1. #1

    Using Ethernet Device module

    Anyone used ethernet module in homework QS for Intersystem communication? I have two programs. I want to use a keypad in program1 to control few channels in the program2.Initial requirement was independent system. Now got a task to control few lights that are in building 1 from building 2. Both are in same network.

  2. #2
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    168
    Thank you for your post Kannan@pv.ae.

    We would recommend following this app note https://www.lutron.com/TechnicalDocu...ntegration.pdf. Specifically scenario 1 would be needed. With that in mind we would need to program both directions for the commands and feedback if needed. Hope this helps!

  3. #3
    Thank you for the suggestions and the app note.

  4. #4
    Junior Member
    Join Date
    Mar 2018
    Posts
    4

    Need help integrating with a 3rd party Ethernet device - any way to debug ?

    I have a gate controlled by a Global Cache TVP/IP Ethernet to contact closure switch. I can telnet to the Global Cache device and issue a command to open or close the contact closure switch (e.g. "setstate,1:1,1"). I have not been able to successfully trigger the command from HomeWorks QS. I have configured an Ethernet device with the IP address, and telnet port number. I have a command set with the appropriate command configured. But it's not working somewhere. Is there any way to debug the integration? Can I see if the Global Cache device is returning an error message?Is there any way to tell how this might be failing?When I issue the command using telnet, the Global Cache device returns an acknowledgment message. How do I see that return message from the HomeWorks QS system?Thanks in advance for your help.

Similar Threads

  1. SageGlass Ethernet Integration - Feedback
    By martopg in forum 3rd-party Integration - HWQS
    Replies: 2
    Last Post: 04-02-2019, 03:26 PM
  2. Serial over ethernet for RS485 link to Aux repeater?
    By EstateNets in forum Design Assistance - RA2
    Replies: 4
    Last Post: 05-21-2017, 01:56 PM
  3. How many device addresses used for Wallbox Power Module
    By SB Smarthomes in forum General Discussion - RA2
    Replies: 1
    Last Post: 06-14-2014, 06:30 PM
  4. Any Ethernet Surge Protection Ideas?
    By jkvossen in forum General Discussion - Legacy HW
    Replies: 1
    Last Post: 01-22-2014, 01:03 PM
  5. MAIN-REP ethernet port
    By hinkelmann in forum General Discussion - RA2
    Replies: 2
    Last Post: 10-31-2013, 01:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •