RR2 Essentials 12.7.0 and a RR2 repeater with 12.7 firmware update. Large configuration - 93 devices, 63 repeater phantom buttons configured. Integrated with HomeAssistant using Telnet. All of this works fine except one issue: After transferring the project successfully, the repeater remains in a transfer state after Essentials reports it is finished, for about 10 minutes: red Communication and Setup test and add LEDs flashing in the usual alternating pattern. I have shut down the Essentials software during this time so it isn't some retained open connection to Essentials. During this time, the repeater does not accept Telnet connections so my 3rd party HomeAssistant integration cannot initialize. After 10 minutes or so, this condition clears on its own, the repeater's LEDs go back to normal operational state, and Telnet connections work again. Power cycling the repeater clears this condition - when it comes back up, Telnet works normally. I reported this on github and a maintainer of the pylutron code base confirmed seeing the same behavior on his configuration, so it isn't just me. It seems to be related to the 12.X firmware series, or perhaps just 12.7 for the RR2 repeater, as it started happening for myself and others after this update. Likely this is the same issue as https://forums.lutron.com/showthread...ll=1#post37225. Could this be a bug in the firmware? Thanks.