Thanks Thanks:  4
Likes Likes:  5
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Transfer is take too long to finish

  1. #11

    Unhappy

    Quote Originally Posted by dimthan View Post
    Did this solve your problem ?
    No, i've tried to upgrade the firmware but it still failure. and on my another jobsite this happen again and there's to many modules that shown failure in the uploading report.

  2. #12
    Authorized Lutron Contributor
    Join Date
    Jun 2013
    Posts
    19
    In the design:equipment screen for those LQSE modules that are failing are there outputs that do not have loads assigned? We have seen issues when you skip outputs (i.e. assign loads to outputs 1,3,4 but not 2). If you move around your loads or create fake loads for those locations does it fix the issue?

  3. #13
    Quote Originally Posted by Chris Y. View Post
    In the design:equipment screen for those LQSE modules that are failing are there outputs that do not have loads assigned? We have seen issues when you skip outputs (i.e. assign loads to outputs 1,3,4 but not 2). If you move around your loads or create fake loads for those locations does it fix the issue?
    in some of my project it fix this issue but there is one of my project that still have this issue and there are too many module that have this issue in this project.
    i have tried to create fake loads for all module that have the issue but it not fix the issue. and i have upload the screenshoot of the report in another thread.

    https://forums.lutron.com/showthread...when-uploading

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Transfer errors
    By Craig W. in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 12-19-2013, 11:44 PM
  2. Failure to enter activation or transfer
    By Craig W. in forum Troubleshooting - RA2
    Replies: 3
    Last Post: 09-23-2013, 03:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •