Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Occupancy Sensor Tests Okay, but Suddenly Stopped Working

  1. #1

    Occupancy Sensor Tests Okay, but Suddenly Stopped Working

    I have an occupancy sensor (lrf2-ocr2b-p-wh) in a hall closet that's worked fine for a year, but suddenly no longer works properly (i.e. it doesn't turn the light on or off).1) When I press the light button on the sensor, the correct light does turn on/off, so it's clearly still paired.2) When I enter test mode, the sensor shows that it's clearly detecting motion.However, out of manually pressing the button or test mode, the sensor doesn't seem to do anything anymore.I have other occupancy sensors in that house of the same model that still work fine. Any ideas?

  2. #2
    Senior Member
    Join Date
    Jun 2013
    Posts
    1,365
    Did you recently update the firmware/software? If so, what version? I would go back into the software and check that the sensor is supposed to turn "on" the closet light and not "off". If it is "off", then you would expect the behavior you are seeing. This type of glitch happened in some of the older software versions where the firmware update would changed the level from some devices in the programming. If that isn't the case, then you might try changing the battery. I know that Lutron says 10 year battery life, but you may have had one that sat a bit too long on the shelf, or just a bad battery from the jump. Correct battery is a CR123.
    Simple automation when DIY isn't working
    intuitivehomecontrols@gmail.com
    fb.me/intuitivehomecontrols

Similar Threads

  1. Lutron Maestro occupancy sensor stops working after 5 minutes or so
    By Thomas5 in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 12-11-2019, 11:46 AM
  2. MA-R (3 way setup) stopped working
    By jmurray110 in forum Troubleshooting - Controls
    Replies: 2
    Last Post: 11-16-2018, 02:30 PM
  3. Geofencing Stopped Working
    By tabraham in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 09-24-2018, 08:56 PM
  4. Lutron dimmer switches stopped working suddenly
    By cmoreman in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 09-10-2018, 10:18 AM
  5. Occupancy Sensor stopped working after 11.6 update
    By mikerpalmer in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 10-21-2017, 10:07 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •