My RadioRa2 installation was done a long time ago 2011 or 2012 I think. It was programmed with essentials.Unfortunately the computer that was used to do the programming met a catastrophic end and there is no backup :(I've done the level 1 training. The system currently works fine but I need to change a few things and add dimmer.I tried extracting the project with essentials 11.6 but the repeater cannot be found.I can ping the repeater.I noticed that the *only* port open on the repeater is 22 (SSH). I swear I used to be able to telnet into the repeater and that it used to have a web interface on port 80. But these ports seem to be closed now.I port scanned the device with nmap and it shows the only open port is 22 (SSH).Is there any way for me to regain access to the system? I'd hate to have to factory reset and start from scratch.If I do need to reprogram from scratch I've read that I need to go back to older versions of essentials and update the firmware version by version until I can use the latest software. Is this true? Where do I get older versions?I've also read that I risk bricking my repeater. I really do not want to do that either.And finally, since my system is 8+ years old is there any chance that any of my devices are no longer supported by the software?