Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Motor doesn't recognise stop

  1. #1
    Junior Member
    Join Date
    Apr 2020
    Posts
    1

    Motor doesn't recognise stop

    Hey,I'm trying to integrate a Motor LQSE-4M. #OUTPUT,ID,2 and #OUTPUT,ID,3 are working correctly. The problem is that after the "Travel time", if you raise or lower and then you try to stop with #OUTPUT,ID,4, the stop command is not working.If you use a button to raise or lower the blind, then the stop command starts to work. Until the next time you use al the travel time.Do you know what's wrong?BTW, despite what the Integration Protocol says, #OUTPU,ID,1,100 doesn't work for motors.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Quote Originally Posted by rzulian View Post
    Hey,I'm trying to integrate a Motor LQSE-4M. #OUTPUT,ID,2 and #OUTPUT,ID,3 are working correctly. The problem is that after the "Travel time", if you raise or lower and then you try to stop with #OUTPUT,ID,4, the stop command is not working.If you use a button to raise or lower the blind, then the stop command starts to work. Until the next time you use al the travel time.Do you know what's wrong?BTW, despite what the Integration Protocol says, #OUTPU,ID,1,100 doesn't work for motors.
    On some motors you have to send stop and down or stop and up.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Maestro MA 600 doesn’t tap on MAR 2 Way doesn’t work
    By Jrusk@ruskrenovations.com in forum Troubleshooting - Controls
    Replies: 3
    Last Post: 03-30-2018, 11:54 AM
  2. Open stop start for motor control
    By stelo66 in forum Programming - HWQS
    Replies: 1
    Last Post: 01-29-2018, 11:14 AM
  3. Open Stop Close Stop with Maintained CCO shades
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 04-01-2015, 12:38 PM
  4. Open Stop Close Stop with pulsed CCO shades.
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 11-05-2014, 11:04 AM
  5. Replies: 0
    Last Post: 07-11-2014, 02:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •