Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: remote A controlling switch B (when not programmed to)

  1. #1
    Junior Member
    Join Date
    Apr 2020
    Posts
    2

    remote A controlling switch B (when not programmed to)

    I have two Caseta wireless wall switches and programmed one Pico remote to one of them and another Pico remote to the other.Problem is, while one remote works correctly and only controls the programmed switch/light, the other remote always controls (turns on and off) BOTH swtiches/lights.I have reprogrammed and reprogramed and the problem persists.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Quote Originally Posted by JayMar View Post
    I have two Caseta wireless wall switches and programmed one Pico remote to one of them and another Pico remote to the other.Problem is, while one remote works correctly and only controls the programmed switch/light, the other remote always controls (turns on and off) BOTH swtiches/lights.I have reprogrammed and reprogramed and the problem persists.
    It sounds like you are not using a bridge. You will need to unpair the devices first. You can find the directions in the link below starting around page 76.

    Resetting device: http://www.lutron.com/TechnicalDocum...structions.pdf
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Apr 2020
    Posts
    2

    Wink Solved!

    Quote Originally Posted by randyc View Post
    It sounds like you are not using a bridge. You will need to unpair the devices first. You can find the directions in the link below starting around page 76. Resetting device: http://www.lutron.com/TechnicalDocum...structions.pdf
    Right, no bridge. Thanks for the fast and successful advice!

Similar Threads

  1. 3-way switch controlling multi-speed fan
    By Speckle in forum Design Assistance - Controls
    Replies: 1
    Last Post: 03-08-2019, 07:39 PM
  2. WOW, 1 pico remote controlling 2 hubs.
    By Sawdust in forum Programming - CAS
    Replies: 6
    Last Post: 04-03-2017, 12:59 PM
  3. Can I use a H6BRL as keypad, whitout load atached or programmed?
    By lleo_ in forum General Discussion - RA2
    Replies: 4
    Last Post: 01-05-2016, 06:48 PM
  4. Programmed via s/w or walk around?
    By jkvossen in forum Troubleshooting - RA2
    Replies: 5
    Last Post: 02-02-2015, 12:32 PM
  5. Trying to raise and lower fixtures just programmed to that button
    By yaniquevirgo in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 07-31-2014, 02:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •