I'm trying to install a remote at the top of the stairs and a PD-5ANS at the bottom. It is a single bulb with a 3 pole switch. I followed the instructions and capped the three wires (red, white, black) at the top. At the bottom, I lost track of the common wire, so I'm not exactly sure how to wire it. I tried the basic way (red on switch to red in wall, black on switch to black on wall, white on switch to white on wall, ground to ground). The LED came on for the switch, but the LED bulb would barely come on (Could only tell it was on in the dark) and an incandescent wouldn't come on at all. Since I lost track of the common, I'm not sure how to wire it. I'm trying to follow the instructions here: http://www.lutron.com/TechnicalDocum...structions.pdf. Interestingly, after capping the three wires at the top of the stairs, at the bottom I have the following voltage:Red to ground: ~10vBlack to ground: ~10vwhite to ground: ~120vThat has me super confused. Anyway, I'm sure I messed up by losing track of the common. Any suggestions I would much appreciate.