Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Dimmer and Pico Remote Together in Same Gang?

  1. #1
    Junior Member
    Join Date
    Mar 2020
    Posts
    1

    Dimmer and Pico Remote Together in Same Gang?

    I have a 4 gang switch. 3 of the switches will be getting dimmers. The 4th switch is already on a 3-way circuit where the other end is attached to a dimmer. Therefore this 4th switch needs a Pico remote instead.Is it possible for me to install 3 dimmers and 1 pico remote into the same 4 gang box? If so, how? More specifically, should I remove any side sections from the dimmer that will be next to the remote?

  2. #2
    Yes, the Pico wallmount can be installed into a junction box. Be sure to *not* remove the plastic piece the instructions mention (that removal is only for wall mounting). Not sure if you have to remove side tabs on the dimmer.

  3. #3
    You do have to remove the tabs next to a Pico else it won't fitThis is equally true for an in box fit or a next to a box wall mount fit on a shared plateAlan

Similar Threads

  1. Unpair pico remote from Caseta dimmer?
    By maarten in forum Programming - CAS
    Replies: 7
    Last Post: 02-25-2021, 01:33 PM
  2. Replies: 1
    Last Post: 12-19-2017, 10:45 AM
  3. Replies: 3
    Last Post: 11-27-2017, 01:03 PM
  4. Pico added to gang
    By Dimerize in forum Design Assistance - CAS
    Replies: 5
    Last Post: 01-20-2016, 01:43 PM
  5. one gang box, two lights and one remote.
    By npriest in forum Design Assistance - Controls
    Replies: 3
    Last Post: 03-10-2015, 05:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •