I recently installed 4 Pro dimmers (PD-10NXD). 2 are 3 way with Pico and 2 are 3 way with mechanical re-wired. All have been connected to the neutral as well. After I installed them I swapped out the bulbs in the cans one of them is controlling so I pulled out the FASS as that's what it's for. Swapped the bulbs and then pushed it back in and ..... lights won't turn on. I tried pulling it out pushing it back in a few times no luck. I did notice that even when it was pulled out the lights on the dimmer switch would illuminate indicating the switch has power. Also when in they would light up and show level but no power to the lights. I finally tried turning off the circuit and turning it back on again and then the switch and lights started working normally. I tried pulling the FASS again to reproduce and it did exactly the same thing as before where the lens on the switch still work but no lights. Went back to the panel and turned the circuit off for a bit then back on and tada every is working again. I have some other Caséta switches and fan controls, these are my first pro dimmers, and the FASS works on the others to cut power to the lights on the switch and everything comes back when I push it back in. Is this normal for the Pro (PD-10NXD)? Is there some other setting I'm not aware of here as this doesn't seem like it is normal to me. Any inputs or additional trouble shooting suggestions would be appreciated.