I would like to use the Maestro dimmers in a 4-way application so I can dim the lights from any location. I looked at the instructions for the Maestro MACL-153M and it shows the LOAD(Light) is at one end of the string using the Brass screw of the switch and the LINE(HOT) at the other end of the string using the Black screw of the switch. The way my wiring is setup is both the LINE and LOAD is at the same location at one end of the string of switches. Can I connect the Line(Hot) to the Black screw and the Load(Light) to the Brass screw on the same Companion Switch at one end of the string. I am assuming that I will be use two of the Companion switch (MA-RR-WH) at each end of the string and the MACL-153M in the middle.