Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Fan operation

  1. #1
    Junior Member
    Join Date
    Feb 2020

    Fan operation

    Hello,i have the Lutron Fan controller installed and understand it will not work with fans that have their own controller/remote and is meant for fans with pull-chains. however, i was wondering if the switches would work simply as an on/off switch for the fan? Obviously the speed control would not work, but that is ok. Or would it be better to get the dedicated light/fan on/off switch that Lutron sells? Thanks,Alex

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Alex,Yes. The Caseta switch will work to just turn the fan on/off. I personally didn't have separate wall controls for my own fan/light combo fixtures. I have the Caseta switches installed to turn the fan/light on and then use the pull chains on the fixture to adjust the speed and the lights. One thing to note: if you have both the lights and fan pull chains set to "off" at the fixture, the indicator LED on the Caseta switch may not work until you turn on one of the pull chains.

Similar Threads

  1. Switch Operation is Reversed
    By chuckc3 in forum Troubleshooting - Controls
    Replies: 8
    Last Post: 07-06-2021, 09:50 AM
  2. Graphic Eye & GRX-RV operation
    By Philip in forum General Discussion - Legacy Other
    Replies: 9
    Last Post: 07-15-2020, 11:08 AM
  3. Single pole operation reversed
    By raini in forum General Discussion - Controls
    Replies: 2
    Last Post: 01-20-2020, 10:39 PM
  4. System Operation/Limitation Questions
    By ekimla in forum Design Assistance - CAS
    Replies: 9
    Last Post: 08-08-2016, 03:34 PM
  5. Sequence of Operation for HVAC controller
    By Iknowmorethanyou in forum General Discussion - RA2
    Replies: 3
    Last Post: 12-05-2013, 08:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts