Hello, I have a RRD-W5BRLIR that went into factory mode yesterday (all LEDs flashing when any button is pressed.) I re-activated the keypad in the project, checked the programming and transferred the program to the repeater. The keypad activated fine, so I'm assuming the radio isn't bad. The LEDs on the keypad work, and light up and turn off when the buttons are pressed, but the loads don't react to commands from the keypad. The loads do work directly from their dimmers and from the Home+ app. The keypad LEDs react to the Home+ app commands, turning on and off as expected. The Home+ app registers the keypad commands when the keypad buttons are pressed, but the loads don't actually respond. Is this a bad keypad - suggestions? Thanks!