Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: LMJ-5T-DV-B "switched line" behavior/control

  1. #1
    Junior Member
    Join Date
    Oct 2019
    Posts
    5

    LMJ-5T-DV-B "switched line" behavior/control

    Can someone please explain to me how the "switched hot" line of the LMJ-5T-DV-B functions? I can see in advanced settings an "on level" which I assume sets a trigger to turn it on but what turns it off?Can anyone provide any insight?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,442
    The LMJ-5T is like 2 devices in 1 but works like any other dimmer. If you need to turn the lights on/off it applies or removes power from the switched hot. If you need to dim, it uses the 10v output.

    The "on level" is the same function as any electronic dimmer. If you physically push the ON button at the LMJ the lights will go the the level you set.

    I'm not sure what your application is but the LMJ does not have any auto-on or sensor capability. You must use the physical buttons on the device or send commands from a RA2 or HQS system to control the lights.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. Replies: 7
    Last Post: 12-11-2019, 11:22 AM
  2. Caseta control with "Ok Google"
    By regulatorfix in forum General Discussion - CAS
    Replies: 2
    Last Post: 12-11-2018, 10:10 AM
  3. "Sivoia QS" versus "QED QS" & extending existing system
    By jfmartin in forum General Discussion - Shades
    Replies: 4
    Last Post: 09-27-2018, 08:57 PM
  4. Replies: 2
    Last Post: 04-03-2017, 02:11 PM
  5. "TRANSFER" resets all occupancy sensors to "Enabled"
    By joshg in forum Programming - RA2
    Replies: 0
    Last Post: 01-15-2017, 02:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •