Hi, ok pretty new to this, so basic explanations/information would be much appreciated. Cannot for the life of me figure out the wiring combination here. I've done a couple other dimmers which are fine.I'm trying to install the CASETA DIMMER with PICO remote into a 3-WAY SWITCH configuration.Behind door #1:1 black (common/hot) wire - was connected to common terminal on switch1 red wire - was connected to a terminal on the switch1 white wire - was connected to a terminal on the switch1 ground - connected to the box, no issue there.Behind door #21 black (common/hot) + tied to it is a wire for another light in the house. I'm assuming these two will stay together to power the other circuit in series.1 black - separate, was on another terminal on the switch1 red - was connected to a terminal on the switchwhite... there are some capped together in the back of the box, they weren't on the original 3-way switchall ground wires tied off to the boxIdeally I'd like to have the dimmer on Door/location #1 and the pico switch on #2.No matter how I connect these I tend to get no power to the light/switch, OR, the light turns on but it's only 50% power/brightness, and the switch doesn't work to turn it on or off at all.PLEASE help, been at this for wayyyy too long.