Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Simple Basic Electrical Question

  1. #1
    Junior Member
    Join Date
    Nov 2019
    Posts
    1

    Simple Basic Electrical Question

    Directions for the dimmer say that you can use only one dimmer per circuit. What defines a circuit? Does each breaker control one circuit? Or is a circuit one complete element - one switch and a light fixture(s)? Specifically, I have installed a dimmer which controls a light. It is not a 3-way because there is only one switch. Controlled by the same breaker are several other switches, including a 3-way that I would like to install a dimmer on? Can I?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,258
    In this case, circuit refers to a group of lights controlled by one or more switches. I prefer the term zone. Your living room is probably fed by a single breaker. You may have 3 zones of light (chandelier, recess, sconces) on that circuit but controlled by 3 different switches. You can have a dimmer on each one of those zones.

    If the chandelier is controlled from 2 locations, both switches are 3-ways. If it is controlled from 3 or more locations, there are 4-way switches between (as the wire goes) the 3-ways. In either case, only 1 of the switches can be a dimmer. Mechanical dimmers like Diva and Ariadni will work with existing mechanical 3-way and 4-way switches. However, the dimmer must replace one of the 3-way switches. You can only dim from the dimmer location and have on/off control from the other locations.

    Some electronic switches, MACL-153M for example, will work with a single, mechanical, 3-way switch. If you have more than 2 locations you use a companion dimmer (MA-R). The advantage of the companion is that you can dim from all locations. You can also use a companion dimmer if you have just 2 locations.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. Electrical drawing\scheme of HWI-WPM-6D-240 board
    By EyalDP in forum Troubleshooting - Legacy HW
    Replies: 1
    Last Post: 11-07-2019, 04:41 PM
  2. New Guy With 2 Basic Questions
    By Chuck43 in forum General Discussion - CAS
    Replies: 8
    Last Post: 08-13-2018, 06:33 PM
  3. New home electrical
    By Macord in forum Design Assistance - CAS
    Replies: 3
    Last Post: 02-17-2018, 07:25 PM
  4. LTEA4U1UKS??Hi-Lume LED driver with electrical back-box)
    By haruba in forum Lutron Hi-Performance LED Driver - LED
    Replies: 1
    Last Post: 03-21-2017, 03:19 PM
  5. New user--basic setup question
    By tb001 in forum General Discussion - RA2
    Replies: 5
    Last Post: 08-22-2014, 05:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •