Thanks Thanks:  0
Likes Likes:  0
Results 1 to 5 of 5

Thread: Ghosting PD-6ANS

  1. #1
    Junior Member
    Join Date
    Nov 2019
    Posts
    1

    Ghosting PD-6ANS

    I have Caseta PD-6ANS wireless switch. My outdoor LED is on continuous very dimmed. This is non dimmed with a connected neutral. Obviously the LED fixture is not compatible, however can Lutron capacitor be installed to correct the issue, if so will a MLC work.
    Only 1 11 watt future.
    Also, if no solution will this shorten my lamp life and how much power am I actually wasting?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    When you turn the lights on do they go to full brightness? If not, there are other issues.

    The MLC is typically used with non-neutral switches when the lights don't turn completely off. Since your switch has a neutral, the MLC probably isn't going to help. It does consume some power. I can't imagine it draws more than a couple of watts.

    Make sure you have power connected to the black lead and the wire going to the light connected to the red wire. Make sure there is nothing connected to the blue wire. If you have a multi-location circuit, refer to "Caseta Advanced Instructions."

    http://www.lutron.com/TechnicalDocum...structions.pdf
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Aug 2020
    Posts
    1

    Similar issue

    Not to hijack this thread, but I’m experiencing a similar issue. My outside light (switch, not dimmer), is not at full brightness.

    You mentioned that if this is the case, there could be other issues. What were you referring to?

  4. #4
    Junior Member
    Join Date
    Aug 2020
    Posts
    2

    Similar Issue

    I have the same issue. PD-6ANS powering an LED light bar through a 110v/15a outlet. I just ordered an MLC. will report back when installed.

  5. #5
    Junior Member
    Join Date
    Aug 2020
    Posts
    2

    Fixed

    This was solved with an MLC. I put it pretty close to the fixture because the switch box was quite full.

Similar Threads

  1. PD-5WS-DV-WH vs PD-6ANS-WH
    By bozack in forum General Discussion - CAS
    Replies: 3
    Last Post: 03-19-2019, 03:23 PM
  2. Replies: 2
    Last Post: 11-14-2018, 04:48 PM
  3. LED glowing/ghosting when dimmer switch is off
    By ajt49 in forum Performance Issues - LED
    Replies: 1
    Last Post: 01-05-2018, 02:26 PM
  4. LED Glow/ghosting while dimmer switch is off
    By ajt49 in forum Troubleshooting - CAS
    Replies: 7
    Last Post: 01-03-2018, 11:49 AM
  5. PD-6ANS help
    By Kzooray in forum Troubleshooting - CAS
    Replies: 5
    Last Post: 10-17-2016, 04:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •