Thanks Thanks:  0
Likes Likes:  0
Results 1 to 6 of 6

Thread: Simple On/Off for existing Florescent and under cabinet LEDs

  1. #1

    Simple On/Off for existing Florescent and under cabinet LEDs

    Hi Guys

    Relatively new to Lutron and RA2. Moved house recently and will be doing a lot of remodeling (including a lot of new electrical and lighting). It's gonna be a while before i'm ready to install new lights and dimmers. in the interim, I'd like to be able to control 3 existing rooms that have florescent and under cabinet LED lights that are currently controlled by regular manual light switches. Not looking for dimming/fading, just simple on/off from my iPhone and automation system. I seem to recall there being a relay switch for RA2, but can't find it. I'm probably don't have neutrals in most of these locations.

    Is there a simple 2-wire switch that will simply turn a load on and off for RA2?

    TIA

    Mark

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    138
    RRD-8S-DV-xx. When adding the device to the software select "Dual Voltage Switch." It has a minimum load of 40 w/va.

  3. #3
    Senior Member
    Join Date
    Jun 2013
    Posts
    815
    If there is a neutral available in the box, you could use the RRD-8ANS-WH. Lower minimum wattage, less cost.
    Business Development Associate for Baker Electric Solar

    mbalay@bakerelectricsolar.com

  4. #4
    Quote Originally Posted by randyc View Post
    RRD-8S-DV-xx. When adding the device to the software select "Dual Voltage Switch." It has a minimum load of 40 w/va.
    Thanks. Haven't removed the diffusers yet (bit of a pain to do). All our 2 bulbs, so as long as they're 20W each or higher, I should be good right?

  5. #5
    Quote Originally Posted by SanDiegoRep View Post
    If there is a neutral available in the box, you could use the RRD-8ANS-WH. Lower minimum wattage, less cost.
    This is a dimmer isn't it?

  6. #6
    Senior Member
    Join Date
    Jun 2013
    Posts
    815
    Quote Originally Posted by mark2457 View Post
    This is a dimmer isn't it?
    RRD-8ANS-xx is the neutral wire switch which has a lower minimum wattage than the RRD-8S-DV-xx (no neutral wire switch).
    Business Development Associate for Baker Electric Solar

    mbalay@bakerelectricsolar.com

Similar Threads

  1. What is best, reasonably priced, under-cabinet lighting for a kitchen?
    By volkalighting in forum General Discussion - LED
    Replies: 4
    Last Post: 11-15-2017, 02:48 PM
  2. Simple bathroom remodel
    By alsanmateo in forum Design Assistance - CAS
    Replies: 1
    Last Post: 07-04-2015, 01:49 PM
  3. Mains voltage dimmable LEDs vs Low Volatge dimmable LEDs with transformers
    By etienneterblanche in forum General Discussion - LED
    Replies: 5
    Last Post: 09-17-2014, 01:27 AM
  4. Downloading an existing program HELP???
    By tazz3069 in forum General Discussion - RA2
    Replies: 2
    Last Post: 06-03-2014, 06:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •