Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: MS-OPS2H - correct face plate for 2 gang / 3 gange with toggle switches

  1. #1
    Junior Member
    Join Date
    Oct 2019
    Posts
    1

    Question MS-OPS2H - correct face plate for 2 gang / 3 gange with toggle switches

    Hi, I have recently installed a couple of single MS-OPS2H switches and the faceplate included what I would guess you call a "bezel" - snap on cover for the face plate. However, I also have a couple of 2 gang and a single 3 gang install but cannot find a face plate for those other than standard faceplate with no bezel. Any one out there who has done a 2 gang/3 gang install have input on what you did? Thanks

  2. #2
    Senior Member
    Join Date
    Jan 2019
    Posts
    142
    You are talking about what is known as a screw less wall plate. I haven’t heard of one that is a combination Decora and toggle switches. You could call Lutron Customer Support and see if they are willing to make you a custom one, but it will be much more cost-effective (and look better) to just switch out the toggle switches with rocker switches. Otherwise, you could use a normal wallplate with the visible screws. Hope this helps!
    Evan Kirkhart- Home Electronics Solutions
    evan@homeelectronics.solutions

Similar Threads

  1. Replies: 2
    Last Post: 07-06-2019, 02:00 PM
  2. 3 gang wall plate - 2 rocker, 1 Pico?
    By regulatorfix in forum General Discussion - CAS
    Replies: 4
    Last Post: 02-08-2019, 02:21 PM
  3. Face plate for 3 gang caseta set up..
    By cwsims84 in forum General Discussion - CAS
    Replies: 3
    Last Post: 04-30-2017, 08:02 AM
  4. New Maestro MS-OPS2H goes rogue
    By JSStewart in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 04-19-2017, 10:53 AM
  5. HWI-8SE-M face plate not in toolbox
    By Brand in forum Programming - Legacy HW
    Replies: 4
    Last Post: 01-14-2014, 12:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •