Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Ballast Replacement

  1. #1
    Junior Member
    Join Date
    Oct 2019
    Posts
    1

    Ballast Replacement

    We received a H3DT524CU110 ballast as a replacement for the obsolete FDB-T524-120-1 ballast.After installation, the lamp is turning on and off about every 7-8 seconds.Nothing has changed except the ballast. We have tried two separate ballasts.Any known problems with this replacement ballast? Any ideas?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,273
    Make sure you don't have anything connected to the EcoSys terminals (E1, E2). Make sure you have the dimmed hot and hot connected correctly. If you are not dimming the light you need a jumper between the DH and HOT terminal.
    LED, Incorporated
    Raleigh, NC 27614

Similar Threads

  1. dimmer for cfl with electronic ballast
    By watts40pc in forum Design Assistance - Controls
    Replies: 1
    Last Post: 06-13-2018, 01:10 PM
  2. Wizard will not assign replacement ballast
    By Tony Buccino in forum Troubleshooting - Quantum
    Replies: 1
    Last Post: 02-26-2018, 10:24 AM
  3. H-Series ballast woes - should I convert to LED?
    By thirty2off in forum General Discussion - LED
    Replies: 0
    Last Post: 09-01-2017, 07:18 PM
  4. RA2 Maestro Dimmer for Lutron Tu-Wire ballast
    By Dimerize in forum General Discussion - RA2
    Replies: 2
    Last Post: 02-05-2016, 07:38 AM
  5. 6NA dimmer controlling Philips Mark 10 powerline ballast?
    By digit1 in forum General Discussion - HWQS
    Replies: 0
    Last Post: 04-07-2015, 01:56 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •