Got a few Victorian-style push-button switches that are tied to Control4 system. When they are pressed, they run scenes to turn various Lutron RadioRA dimmers and switches on and off. I know Lutron programming but not Control4.I would like to replace a few of the Lutron switches with RRD-PRO dimmers. The ones I want to change are used in Control4 scenes.In RadioRA 2 Essentials, I would go to the Design tab, select the Room, Edit Device, then select "Choose Alternate Model", select RRD-PRO, put in the serial number in the Activate tab, etc.My question is whether this would mess up the Control4 programming.If I change a switch or dimmer in Lutron using the Edit Device + "Choose Alternate Model" then reactivating, does the switch or dimmer keep the same ID? At least on the Lutron side, I don't appear to have to reprogram multi-room scenes or path of light.Does Control4 reference switches and dimmers via ID (vs. serial number or name)? If I swap out an RRD-PRO dimmer for an RRD-8ANS switch, would Control4 try to set the dimmer to 100% for on and 0% for off? Or would it stop working because there's a dimmer in place of a switch?