Background: We have been transitioning a Illumination system from Homeworks to QS. The system has two Generac 17KW generator tied to the home. With the Illumination system I remember I had to adjust the PLL settings to “off” because the lights were flashing when the generator system kick on. Now that we have coverted the system to QS the lights will turn on then in a short few seconds the lights that are on the emergency system will start to cycle on then off. Some of lights will flicker then just completely turn off. I can get them not to cycle when I dim the load. Currently the High Low setting are set to 90% - 5%. Not sure exactly what this means. My question is where is the PLL setting and how do I turn it off? When I turned that off in Illumination it works perfectly. Also another questions: When the generator system kick on it turns on all of the H48 devices and they cannot be turned off with the app or a keypad. You have to walk the house and manually turn them off. The owner also doesn’t like that the some of the RMP loads will turn on after the power is restoredThank you for your responses.