Hey Lutron fans. I am in the process of switching over from a SmartThings based Z-Wave system (old Vera based Z-Wave system) to a dedicated Lutron Caseta system. Now that the bridge will support 75 devices, this is finally feasible. Unfortunately, with pico remotes included, I would need closer to 100. What I would like to do is have all of my actual devices on one hub. This hub would syn with SmartThings & Homekit and would be used to automation across other platforms via these two systems. I do not need the remotes for either of these cases. I am not looking to monitor the remotes, tie actions to them or anything like that. I am fine with the remotes only controlling their paired switch (or two if possible) via the Lutron Bridge.However, I do need the remotes because of multiple 3-way (and one 4-way) setup and for 10 lamp modules I will have in the system. I know I can setup two bridges and that they require separate email and registration for each. If I can put all of the devices on one bridge and all of the remotes on the other bridge, then I would never need to access the second bridge for device control.If this does not work, I have a Plan B so its not the end of the project, I fear linking two bridges through Homekit and SmartThings may be problematic.Thanks,Chris