I have a client that has a room off of the house which has windows on 3 sides (the fourth side is against the house). Client would prefer to have 2 drapes which meet in the center of the far wall and open across and then down the sides and stack in the corner by the house; a perfect application for curved drapery tracks.
When I plug the track lengths into SCT, I get the following warning/error
Maximum leg length exceeded for given configuration. If one leg is greater than
or equal to 6' then the other leg must be less than or equal to 6'
for this application, the drive leg is 110" and the idler leg is 90"
control would be QS wireless
any idea on how I can provide a curved drapery track for this client?