Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: RRD-3LD Lamp Dimmer in switching mode using RA2 Select?

  1. #1
    Senior Member
    Join Date
    Oct 2015
    Posts
    100

    Question RRD-3LD Lamp Dimmer in switching mode using RA2 Select?

    Hello,The specs of the RRD-3LD lamp dimmer mention the device can be put in switching mode. I remember seeing the option when using Inclusive, but what about when using RA2 Select? I don't see the option anymore. Thank you for any help.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    I looked in the RA2 manual programming guide and the 3LD submittal and install instructions and didn't see anything.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Jan 2015
    Posts
    4

    Check out the advanced programming guide...

    Hello!Page 5 of the Ra2 Advanced Programming Guide shows how to swap between dimmed and switched modes. It requires going into the dimmer's advanced programming mode (APM) using button presses to get to the secondary APM. I'm sure Lutron Tech support could talk you through it as well. This is only for devices programmed through button presses though and not through the PC. If you want to do it through a PC programming the system, you have to select the dimmer and then "edit" (while in the design tab) and then choose the an appropriate non-dimmed (or switched) load type. Let me know if there's any other info that will help!

  4. #4
    Junior Member
    Join Date
    Jan 2015
    Posts
    4
    Oh I see your question was specific to Ra2 Select. Not sure if this is possible...

Similar Threads

  1. Switching a Receptacle using a Dimmer
    By Shandley in forum Design Assistance - RA2
    Replies: 2
    Last Post: 12-11-2018, 01:52 AM
  2. Replies: 3
    Last Post: 12-06-2017, 08:57 PM
  3. pj2-4b-gwh-s31 With a lamp dimmer
    By ajiuO in forum General Discussion - CAS
    Replies: 0
    Last Post: 11-07-2016, 11:11 AM
  4. Set Plug In Dimming Module to Switching Mode?
    By geofry in forum General Discussion - RA2
    Replies: 6
    Last Post: 06-07-2016, 09:38 PM
  5. Replies: 3
    Last Post: 04-18-2016, 02:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •