I have two Maestro Dimmers on two separate circuits. There is no shared neutral, I double check it.
Dimmer 1 is attached to a single bulb.
Dimmer 2 is configured as a three way switch. It had the companion dimmer on the other end. This is connected to 8 LED bulbs with a total draw of 120 Watts.
If I start dimmer 1 first.
When I Dim Dimmer 1 to the low settings, Dimmer 2 will not start, I see the light at the lowest level on Dimmer 2 but it won’t go any higher.
When I raise the dimmer level of dimmer 1, Dimmer 2 would work normally and have that soft start that I programmed.
If I start dimmer 2 first. Dimmer 1 works without any issues.
I’m out of ideas. Any help would be appreciated.
- - - Updated - - -
These are Maestro Dimmers to make it clear.