Originally Posted by
waltege
Recently took over management of RadioRA 2 system. Was attempting to add Open Connect and make some minor name changes using latest version of Essentials software. Firmware portion appeared to succedd, but transfer failed. Now I see a LED status code with RF, Wired, Add, and Test status LEDs blinking green, once every 2-3 seconds, and no IP present on the attached router. Reading through the forums, I see some entries speaking of connecting the computer running Essentials software directly to the Main Repeater using an Ethernet cable. I'm not sure this is an option, since I no longer see an IP registered on the previously connected router to avoiding using the same IP when manually setting this on the computer. Any suggestions would be greatly appreciated.