Thanks Thanks:  2
Likes Likes:  2
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: LED flicker when dimmer at and near full brightness setting.

  1. #1
    Junior Member
    Join Date
    May 2019
    Posts
    1

    Question LED flicker when dimmer at and near full brightness setting.

    A Lutron dimmer has begun to cause LED bulb flickering at and near full brightness setting.

    The dimmer switch has a brightness level setting slider at the right side of the on/off paddle switch. The brightness setting is usually set to maximum. Until now, this dimmer has been flawlessly controlling 6 small LED bulbs. Now, the LED bulbs are flickering at and near full brightness. The flickering isn't at a continuous frequency, it is sporadic. If I set the brightness to 3/4 or lower there's no flickering. I have "exercised" the dimmer level slider by repeatedly sliding it up and down between minimum and maximum then leaving it at maximum brightness but that hasn't stopped the LED bulb flickering.

    What is the cause of this problem?
    Last edited by Grim Reaper; 05-18-2019 at 12:16 PM. Reason: added some detail

  2. Thanks Justin F. thanked for this post
    Likes Justin F. liked this post
  3. #2
    Senior Member
    Join Date
    Jan 2019
    Posts
    128
    Many things could be the cause of this problem. With LED dimmer issues, there's no one given solution to every problem. I think you're describing what's known as "shimmer" where the brightness of the bulb sporadically changes. If you changed the bulbs, the new ones could have different (inferior) control circuitry. It is also possible that the dimmer was not designed with LEDs in mind. To answer your question with any level of accuracy, you'll need to provide the model number. If you remove the wallplate and dimmer from the wall, there will be a sticker on the side with the model number. It would also be helpful to give the manufacturer and model number of the LEDs. Sliding the control up and down is unlikely to do anything.

    TL;DR: Can't tell you without model no. of dimmer and bulbs.

  4. Thanks Justin F. thanked for this post
    Likes Justin F. liked this post

Similar Threads

  1. How do you change the LED brightness on the RRD-6ND dimmer?
    By psychobunny in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 04-13-2019, 11:35 AM
  2. In-wall light dimmer (PD-6WCL) - only 80% maximum brightness?
    By nester in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 07-31-2017, 07:26 PM
  3. Replies: 3
    Last Post: 11-09-2016, 09:51 AM
  4. MA-LFQHW light swtich turns on fan on full brightness
    By teepee1232 in forum General Discussion - Controls
    Replies: 2
    Last Post: 10-09-2016, 09:14 AM
  5. Mastro fan and light control will not hold full brightness
    By cleaner in forum Troubleshooting - Controls
    Replies: 1
    Last Post: 03-18-2014, 05:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •