Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Is 1% the lowest low end trim possible?

  1. #1

    Is 1% the lowest low end trim possible?

    Maybe a dumb question but when I used Caseta, you'd set the low end trim on the dimmer using a key combination. I could get it incredibly low to the point that you could barely even tell my pot lights were on. With RA2, I see the test low end trim and how to set it, but 1% still seems significantly brighter than what I could do with Caseta. It feels more like maybe 5% or so on the Caseta if not higher. Just wondering if there's a way to go lower or if 1% in the software is the best you can get.

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    I believe all the non-10v dimmers dim in 1% increments with 1% being the lowest. Mildly surprising that there is that much of a difference. I'm assuming you are comparing CL vs CL dimmer?

    Lutron.com/led has report cards on fixtures they have tested. There are minor discrepancies between the same type devices. Maestro CL vs Maestro sensor CL, HomeWorks RPM vs myRoom RPM, etc.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Low end trim and LED Tape issues with LTE 2 wire Hi-lume driver
    By dvpvic in forum Lutron Hi-Performance LED Driver - LED
    Replies: 1
    Last Post: 05-01-2018, 05:52 PM
  2. Cree LED Low End Trim
    By amattas in forum Programming - RA2
    Replies: 3
    Last Post: 01-28-2018, 10:02 AM
  3. Low/high end trim not honoured by iOS app/homekit
    By tristank in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 10-29-2017, 12:56 PM
  4. Lowest Dimming Bulbs
    By Drake0508 in forum Troubleshooting - CAS
    Replies: 0
    Last Post: 04-16-2017, 08:17 AM
  5. Lowest Dimmimg Bulbs
    By Drake0508 in forum General Discussion - CAS
    Replies: 0
    Last Post: 04-15-2017, 11:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •