-
MS-Z101 will not dim
2 20W led fixtures, hard wired with neutral, yellow green wire connected to neutral, MS-Z101 has full light on, dimmer switch has no effect, also very mild random flickering. Had two electicians look at instuctons and device. They found wiring diagram for single-pole confusing.
-
Authorized Lutron Contributor
Hello Jkircher,
Thank you for your post! Please see the wiring diagram for the MS-Z101 0-10v dimming control for a single pole application @ http://www.lutron.com/TechnicalDocum...93_Page_60.pdf
If you have any issues with wiring in or problems after wiring in, we would advise to give our Tech Support group a call to assist with identifying the root cause of the issue. They are available 24/7 and can be reached @ 1-888-Lutron1 (588-7661)
Hope this info helps!
-JustinF.
-
[QUOTE=Justin F.;32221]Hello Jkircher,
Thank you for your post! Please see the wiring diagram for the MS-Z101 . .
The problem is that there is only two wires coming from the two wall sconces, a black and a white. The two LED fixtures were wired with only a black and white wire, and the fixture did not have any other wires, violet, grey, or otherwise. Is there another motion senser/dimmer low voltage available for this situation?
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
I guess I should reread your response at least twice before reacting. I will call support.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
-
The MS-Z101 is a 10v dimmer. It will switch the lights on/off through the line voltage connection (the black/white wires you mentioned). It dims the lights using a 0-10v signal. You would need a separate low voltage cable from the dimmer to the fixtures (can be daisy chained).
If your fixture does not have the violet/gray wires it is not a 0-10v driver. You would need the MSCL-OPS6 dimmer/sensor for that.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes