After installing the switch i get this error:

Top and middle LEDs are blinking rapidly. - : - Product detected an MLV fault (PRO Dimmer only)� Connect Neutral to the dimmer (required for MLV load)

Im troubleshooting and trying to change the phase on my ELV dimmer as per below:

CHANGE PHASE OF ELV+ DIMMER
DIMMER OFTEN COMES REVERSE PHASE(ELV). TO SWITCH BETWEEN FORWARD AND REVERSE PHASE:
1. CYCLE DIMMER- PULL OUT THEN PUSH IN SERVICE SWITCH AT BOTTOM OF DIMMER
2. HOLD DOWN ON AND OFF BUTTONS UNTIL A TOP OR BOTTOM STATUS LIGHT BLINKS (~ 6 SECONDS)
3. TOP BLINK=FORWARD PHASE (MLV, INCAN.) BOTTOM BLINK=REVERSE PHASE (ELV)
4. PRESS FAVORITE BUTTON TO TOGGLE BETWEEN FORWARD AND REVERSE PHASE
5. SAVE BY PRESSING BOTTOM/OFF BUTTON UNTIL BLINK STOPS (~ 6 SECONDS)
6. SOMETIMES DIMMER WILL LOCK ON FULL. USUALLY A REPEAT OF STEP #1 WILL SOLVE THIS

Im following the instructions but when I hold on and off for 10+ seconds nothing happens. I reset the switch and tried again but still nothing.

Please help.

I originally had the Non Pro dimmer installed and it would flash my lights on start up (no issues dimming the leds afterwards though) and thought id try out the ELV dimmer to see if it fixed the problem. Now i have no light at all lol.

Fun times.