Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4

Thread: HWQS All Lights Turn on then off after about 30s

  1. #1
    Junior Member
    Join Date
    Mar 2019
    Posts
    1

    HWQS All Lights Turn on then off after about 30s

    Wondering if anyone has seen this before. The customer is complaining about the lights every once and a while the whole house will turn on and then @ 30s later turn off. I'm guessing its the emergency load programming (which is set to No (100%))however not to sure how to confirm this. They don't complain about the power going out in the house?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Have them note the exact time. Check the processor log.

    The last time I saw this was someone set a box on top of the tabletop keypad in the kitchen. It was just the right weight to randomly push buttons.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

  3. #3
    Junior Member
    Join Date
    Mar 2019
    Posts
    4
    HiHave them note the exact time and also check the TIMECLOCKs in your program section.

  4. #4
    Open HWQS Designer and go to Tools and Where Programmed. From this screen you'll be able to see any input that affects the loads that turn off after 30s. I can't stress how valuable this tool is for finding mystery actions.

Similar Threads

  1. Lights don't turn off completely
    By cdaniel66 in forum General Discussion - Controls
    Replies: 1
    Last Post: 06-14-2018, 08:35 PM
  2. Lights flicker when they turn on
    By scallaghan in forum Troubleshooting - CAS
    Replies: 1
    Last Post: 03-05-2018, 07:20 PM
  3. Can't turn lights off anymore
    By ramala in forum Troubleshooting - CAS
    Replies: 4
    Last Post: 02-19-2018, 11:41 AM
  4. Why don’t my lights turn on/off automatically like they should?
    By Rob L. in forum Troubleshooting - Quantum
    Replies: 0
    Last Post: 01-29-2016, 01:05 PM
  5. Lights turn on by themselves
    By randyc in forum Troubleshooting - RA2
    Replies: 5
    Last Post: 11-11-2014, 12:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •