I'm working on interfacing with a SageGlass tinting glass system via Ethernet. I've gotten the control of the system to work but the feedback is not working as expected. I followed the process shown in "Scenario 2: Integration with Ethernet Connected Devices Using Custom Integration Commands" of the "Integration with Ethernet and RS-232 Devices" doc.
The commands to/from the SageGlass controller are in hex. When the glass reaches the desired tint level, the controller does send a specific hex message and I configured that as the "From Ethernet Device" command that sets the state variable accordingly. On a PC connected to the controller, I can see it sending that hex string when the glass reaches the desired level (after several minutes), but I don't see my Lutron button LED update. I checked the variable in terminal and it never leaves state 1.
From what I can tell, Lutron is actually setting that variable to state 1 every time it receives any command from the SageGlass controller...
"
Friday, March 29 2019 at 19:49:45 - ~SYSVAR,4,1,1
Friday, March 29 2019 at 19:49:54 - ~SYSVAR,4,1,1
Friday, March 29 2019 at 19:50:03 - ~SYSVAR,4,1,1
"
Any ideas?
Thanks!