Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3

Thread: SageGlass Ethernet Integration - Feedback

  1. #1
    Junior Member
    Join Date
    Aug 2016
    Posts
    16

    Question SageGlass Ethernet Integration - Feedback

    I'm working on interfacing with a SageGlass tinting glass system via Ethernet. I've gotten the control of the system to work but the feedback is not working as expected. I followed the process shown in "Scenario 2: Integration with Ethernet Connected Devices Using Custom Integration Commands" of the "Integration with Ethernet and RS-232 Devices" doc.

    The commands to/from the SageGlass controller are in hex. When the glass reaches the desired tint level, the controller does send a specific hex message and I configured that as the "From Ethernet Device" command that sets the state variable accordingly. On a PC connected to the controller, I can see it sending that hex string when the glass reaches the desired level (after several minutes), but I don't see my Lutron button LED update. I checked the variable in terminal and it never leaves state 1.

    From what I can tell, Lutron is actually setting that variable to state 1 every time it receives any command from the SageGlass controller...

    "
    Friday, March 29 2019 at 19:49:45 - ~SYSVAR,4,1,1
    Friday, March 29 2019 at 19:49:54 - ~SYSVAR,4,1,1
    Friday, March 29 2019 at 19:50:03 - ~SYSVAR,4,1,1
    "

    Any ideas?

    Thanks!

  2. #2
    Junior Member
    Join Date
    Aug 2016
    Posts
    16
    I confirmed with a packet sniffer that the QS processor is - indeed - getting the proper hex string from the SageGlass controller when the glass reaches the desired state. But... every time the processor receives that string, it sets the state variable to state 1 (instead of the actual state).

    Unfortunately, this gives me more data but does not get me closer to a solution...

  3. #3
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    Send an email to support@lutron.com. It will get sent to engineering. It may take a couple of days but they will get it.

    Obviously you want to include the program file, log files, support files, etc.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. Serial over ethernet for RS485 link to Aux repeater?
    By EstateNets in forum Design Assistance - RA2
    Replies: 4
    Last Post: 05-21-2017, 12:56 PM
  2. Virtual / Fake dimmer for integration feedback
    By Dagobert in forum 3rd-party Integration - CAS
    Replies: 10
    Last Post: 11-02-2016, 04:32 PM
  3. Toggle Ethernet Ports on Processor Between 10/100 mbps
    By Armando B. in forum Design Assistance - HWQS
    Replies: 3
    Last Post: 05-22-2014, 10:34 AM
  4. Any Ethernet Surge Protection Ideas?
    By jkvossen in forum General Discussion - Legacy HW
    Replies: 1
    Last Post: 01-22-2014, 12:03 PM
  5. MAIN-REP ethernet port
    By hinkelmann in forum General Discussion - RA2
    Replies: 2
    Last Post: 10-31-2013, 12:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •