Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: CAn the LMJ-5T-DV-B module dim non 0/10v loads?

  1. #1

    CAn the LMJ-5T-DV-B module dim non 0/10v loads?

    I was under the impression that the LMJ-5T-DV-B J-Box module was only for 0/10 volt loads, but the cut sheet lists MLV/ELV... etc. Can this module act as a dimmer for non 0/10 volt loads? If not, is there one that can (I can only find the soft switch)?
    Audio, Video, Networking, & Automation Designed Around You

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    1,099
    No. It can switch MLV, ELV, etc. but can only dim 10v loads.

    I'm not sure what your application is but if you need to mount to a j-box, I have used a box extender and a RS cover to install the switch directly in the j-box.
    LED, Incorporated
    Raleigh, NC 27614

  3. #3
    That’s what I figured...

    This is for a pretty unique application (lighting showroom) where the Jbox module would be much easier to implement of separate fixtures.
    Audio, Video, Networking, & Automation Designed Around You

Similar Threads

  1. what switch is best for non dimming loads?
    By matalhdmatt in forum Design Assistance - RA2
    Replies: 2
    Last Post: 03-17-2019, 10:05 AM
  2. Switch florescent loads on/off (no dim)
    By mark2457 in forum General Discussion - RA2
    Replies: 1
    Last Post: 11-04-2015, 03:24 PM
  3. Assigning Loads in QS 8.3
    By Kevin Craig in forum Design Assistance - HWQS
    Replies: 2
    Last Post: 08-17-2015, 06:18 PM
  4. Replies: 1
    Last Post: 12-10-2014, 11:28 AM
  5. loads not responding
    By Craig W. in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 05-22-2013, 07:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •