I just purchased a house with Lutron installed - I'm not a very educated user so please excuse if anything isn't named correctly and please let me know if anything isn't correct...
I was trying to set the limits of a shade, with both the drive and they keypad. After a few failed attempts I thought to do a factory reset of just those shades and might have followed the wrong instructions by e.g. tripple clicking the top of the keypad. In any case, eventually all shades throughout the house started to go up and down in short intervals (not close or open fully) and I had to unplug the motor-control unit. Upon plugging it back in, all shades throughout the house show up in red. The keypads will just blink a few times green when pressing the shade button and none of the shades respond.
Any ideas?
Thanks!