I have the grafix eye qs. Reading through the manual there are references to using the power module. What is the advantage or when would I want to use the external power module? In my case, across all 6 zones, I have 26 led cans.
I have the grafix eye qs. Reading through the manual there are references to using the power module. What is the advantage or when would I want to use the external power module? In my case, across all 6 zones, I have 26 led cans.
The power module is for large loads and uses another dimmer or graphic eye zone as a control method. Hard to see where the 26 LED cans would require one, unless you have a very high number on a single zone in the GE. How do those cans lay out on the six zones?
Simple automation when DIY isn't working
intuitivehomecontrols@gmail.com
fb.me/intuitivehomecontrols
The power module can be used for different load types. If you LEDs need reverse-phase/trailing edge control, you will need a power module with the Grafik Eye.
Convergence Technologies Raleigh, North Carolina
www.convergenceusa.com
Simple automation when DIY isn't working
intuitivehomecontrols@gmail.com
fb.me/intuitivehomecontrols
Good Morning!I have a question regarding dimming hi lume tuwire drivers with a Grafik QS. I know that I can dimm direct to a zone in the Grafik QS unit 10 LED drivers. We have an application that a zone has 78 drivers. Can I use 3 PHPM-PA as power boosters to dim 26 drivers with each one? I know that an RPM-4A module can operate 26 drivers total. Please advise,thanks
I would call tech support, this sounds like a commercial application that would need to go through the engineering team.
Simple automation when DIY isn't working
intuitivehomecontrols@gmail.com
fb.me/intuitivehomecontrols