Hello,
I am having an issue with a new fixture a client put up. Its a very delicate chandelier. I can't even get in to see the lamps in it. When I turn the load on on the output of an RPM-4A, I can measure 120V across all four outputs, and it lights up the lamps that are on the other outputs. I have tried another module, I don't have the jumper installed, tried different terminal blocks, etc. This module only has one other load connected to it (a couple table lamps). I called into tech support and the technician said that the module is acting normally and when I put loads on the other two outputs, this issue will go away. Trouble is, I have no other loads to add at this time.
I'm suspecting this is some type of minimum load issue, and toying with putting a dummy load on the other outputs, but I wanted to see if anyone else has experienced this.