Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: QS Palladiom in tool box

  1. #1
    Junior Member
    Join Date
    Jun 2016
    Posts
    9

    QS Palladiom in tool box

    In my 11.5 tool box the Palladiom keypads available only are shown without faceplate? how do I add a HQWT-U-P2-W-WH ?

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    2,587
    This has been fixed in 13.2. If you have a single-gang keypad you get the HQWT-U (base/plate together). If you have multi-gang keypads you get the base units and plates listed separately.
    Convergence Technologies Raleigh, North Carolina
    www.convergenceusa.com

Similar Threads

  1. New LED Compatibility Tool
    By Jai H. in forum Compatibility - LED
    Replies: 6
    Last Post: 02-07-2022, 09:28 PM
  2. adding to tool box
    By Fenton in forum Design Assistance - HWQS
    Replies: 2
    Last Post: 08-27-2018, 08:37 PM
  3. Metric measurements for IHA Tool
    By domino in forum General Discussion - Shades
    Replies: 1
    Last Post: 05-25-2017, 07:37 AM
  4. QED R100 Flash Tool?
    By digit1 in forum Troubleshooting - Shades
    Replies: 3
    Last Post: 05-17-2017, 09:28 AM
  5. LED Selction Tool HQRD-6NA v. CL?
    By AndyM in forum Compatibility - LED
    Replies: 1
    Last Post: 12-01-2014, 09:38 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •