Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Claro plate trick?

  1. #1

    Claro plate trick?

    What’s the trick to get perfectly aligned controls in claro wall plates. I’m being a bit obsessive but i have a really hard time getting the control perfectly flush with the wall plate. The gap creates a noticeable shadow. What’s the trick to get things lined up perfectly?

    Thanks!

  2. #2
    Authorized Lutron Contributor
    Join Date
    Sep 2018
    Posts
    87
    Hello Voltron4lyfe,
    Thank you for your post. I was able to locate a Youtube video that goes over the installation of a Lutron screw-less wallplate @ https://www.youtube.com/watch?v=b-pcSTTYAts. It sometimes takes a few attempts to get it lined up just right to have the wallplate look uniform with all the controls.

    Hope this info helps!

    -JustinF.

Similar Threads

  1. proper alignment for Claro screw-less wallplate
    By kposcic in forum Best Practices - Controls
    Replies: 1
    Last Post: 02-06-2018, 08:50 AM
  2. Face plate for 3 gang caseta set up..
    By cwsims84 in forum General Discussion - CAS
    Replies: 3
    Last Post: 04-30-2017, 07:02 AM
  3. Laser engraving Claro wall plates and Ra2 buttons?
    By wkearney99 in forum Design Assistance - RA2
    Replies: 5
    Last Post: 03-24-2017, 10:59 PM
  4. Replies: 3
    Last Post: 11-14-2015, 11:24 AM
  5. HWI-8SE-M face plate not in toolbox
    By Brand in forum Programming - Legacy HW
    Replies: 4
    Last Post: 01-14-2014, 11:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •